spiral gear

Spiral bevel gears are usually created from hardened steel. The teeth of these gears are usually ground for a more precise finish enabling little sound at high speeds. You can specify left hands or right hand depending on the direction you need to run the gears

If you have a higher speed application that requires a whole lot of torque after that spiral bevel gears certainly are a great option. The gears run at 90° to each other and also have “spiral” shaped the teeth which gives maximum tooth surface contact while rotating. With contact spread over the complete tooth the spiral bevel equipment can be run much quicker than the straight tooth bevel equipment and handle harder begins and stops.

We make spiral bevel gears limited to industrial applications.

Worm gears are used in large gear reductions. Gear ratio ranges of 5:1 to 300:1 are normal. The setup was created so that the worm can change the gear, but the equipment cannot switch the worm. The angle of the worm is definitely shallow and consequently the gear is held set up due to the friction between the two. The gear is situated in applications such as conveyor systems in which the locking feature can act as a brake or a crisis stop.

The model cross-section shows an average placement and utilization of a worm gear. Worm gears possess an inherent protection mechanism built-in to its design since they cannot function in the reverse direction.

Tags:

Recent Posts